![]() READONLY Specifies that the disk is read-only. SET Sets the specified attribute for the selected disĬLEAR Clears the specified attribute for the selected disk. The above reply might happen, if so, then follow the below, if not, then follow same process in lower case (in the very last 2 steps below)…įor more information on the command type: HELP ATTRIBUTES DISKĭisplays, sets, or clears disk attributes for the selected disk. The arguments specified for this command are not valid. IT’S IMPORTANT TO USE CAPS WHEN CMD line STARTS INDICATING IN CAPS -ĭISKPART> select disk 2 (select the disk you want to correct)ĭISKPART> attributes disk clear read only.NOTE: IF YOU SELECT VOLUME INSTEAD OF DISK THIS PROCESS WILL NOT WORK! These instructions are for W10 & WD 4tb MyBook, to solve this read-only problem happening to me suddenly like a bolt out of nowhere (Please share when possible): open CMD dialog Volume 6 F 8TBwdB#f2g$ exFAT Partition 7452 GB Fehlerfrei Schreibgeschützt : Nein (not read-only protection) Using DISKPART with fokus on this HD with “attributes disk clear readonly” does not help.ĭatenträger-ID: “”Īktueller schreibgeschützter Zustand: Nein I can’t change this to regular read/write modus. Running WD “Drive Check” also shows no error. Running Windows “Drive Check” shows no error. My WD HD WDBBGB0080HBK-EESN 8TB My-Book was farmated under Windows 7 with exFAT.Īfter working few monthts OK, sudently changed to read-only.
0 Comments
Leave a Reply. |